Dimplex Faber ALBANY ECO ABN15 ECO Mode D'emploi page 11

10. Close the drawer fully.
Additional Information
Recycling.
For electrical products sold within the European Community. At the end of the electrical products useful life it
should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local
Authority or retailer for recycling advice in your country.
After Sales Service
Should you require after sales service, please get in touch with the supplier through whom you purchased the appliance.
Troubleshooting
Symptom
The flame effect will
not start.
The flame effect is
too low.
Unpleasant smell
when unit is used.
The flame effect has
too much smoke.
Cause
Mains plug is not plugged in.
Low water level. CD01 will be
displayed on the remote control
The transducer is connector not
connected properly. (See Fig.6)
The Transducer Unit is not sitting
correctly in the sump
Flame effect is set too low.
The Metal Disc in the transducer
might be dirty (See Fig.12)
The wire from the Transducer Unit is
sitting over the metal disc
Dirty or stale water.
Using unfiltered tap water.
Flame effect setting is too high.
Corrective Action
Check plug is connected to wall socket
correctly.
Check that the water tank is full and
there is water in the sump.
Check that the connector is inserted
correctly. (See Fig.6)
Ensure the Transducer in sitting down
into the moulded recess in the sump
Increase level of flame by changing the
FIRE setting on the remote control
See 'Adjust the Flame Setting'
Clean the Metal Disc with soft brush
supplied. (See Fig.12) See
'Maintenance.' for a step by step
procedure.
Direct the wire to the back of the sump
and make sure it sits into the side slot
exiting the sump.
Clean the unit as described under
maintenance.
Use only filtered tap water.
Decrease the level of flame by changing
the FIRE setting on the remote control
See 'Adjust the Flame Setting'
11