Husqvarna K6500 Ring Manuel D'utilisation page 10

General
WARNING! Always pull out the plug from
!
the outlet socket before cleaning,
maintenance or assembly. Unexpected
blade movements can cause serious
injuries.
Husqvarna's diamond blades are approved for hand-held
power cutters.
We offers a number of blades for different materials in its
range. Check with your Husqvarna dealer to see which
blades are best suited for your usage.
Fitting the blade
WARNING! Do not put new diamond
!
segments on a used blade core (re-
tipping). The blade core is designed to
handle the stress it is exposed to during
the use of the original segment. If the
blade is re-tipped the additional stress
on the blade core might it to break or
crack and cause serious injury to the
operator. For this reason Husqvarna
does not approve ring cutting blades that
have been re-tipped. Contact your
Husqvarna dealer for instructions.
WARNING! Check that the blade is not
!
damaged before fitting it on the machine.
Damaged blades can disintegrate and
cause serious personal injury.
• Wipe off any dirt from the surface of the blade.
• Loosen the locking nuts on the support roller cover.
10 – English
ASSEMBLING AND ADJUSTMENTS
• Unscrew the adjuster screws a few turns.
• Loosen the knob to offload the springs.
• Remove the four screws holding the support roller
guard using a 6 mm hex key and lift off the cover.
• Fit the blade.
The blade has a groove (1) on one side that acts a the
guide groove for the support rollers. Ensure that the V-
shaped edge of the blade enters the drive wheel and
that the blade's guide groove fits in the guide rollers.
See instructions in the section "Blades".