Porter Cable PXCM601 Manuel D'instructions page 6

4. To prevent damage to tank and compressor on stationary models, the
tank must be shimmed so the pump base is level within 1/8" to distribute
oil properly. All feet must be supported, shimming where necessary, prior to
attaching to the floor. Fasten all feet to floor. We also recommend the use of
vibration pads (094-0137) under tank feet.
5. Fasten the compressor down securely if transporting is necessary. Pressure
must be released from the tank before transporting.
6. Protect the air hose from damage and puncture. Inspect them weekly for
weak or worn spots, and replace if necessary.
7. To reduce the risk of electric shock, do not expose to rain. Store indoors.
CAlIfoRnIA PRoPosItIon 65 wARnIng: This product contains chemicals
known to the State of California to cause cancer, birth defects and/or
reproductive harm.
MoDEl no.
PXCM601
bAsIC AIR CoMPREssoR CoMPonEnts
The basic components of the air compressor
are the electric motor, pump, pressure
switch and tank (see Fig. 1). The tank may
be vertical or horizontal, varying in size and
capacity.
The electric motor (see A) powers the
pump. The electric motor is equipped with
an overload protector to help prevent
possible motor burnout. If the motor
becomes overheated, the overload protector
will shut it down. Should this occur, allow the
motor to cool for 10-15 minutes, then press
(never force) the motor reset switch to restart
the motor.
The pump (see b) compresses the air and
discharges it into the tank.
The tank (see C) stores the compressed air.
wARnIng
sPECIfICAtIon CHARt
tAnK
RunnIng CAPACIty
H.P. gAllons
60 (227,
3.7
1)
6- ENG
VoltAgE/
AMPs/ KICK-In
PHAsE PREssuRE
125
(8.62 bar)
240/15/1
NOTE: See pages 8 & 9
for typical installation
of the 60 gallon model.
KICK-out
PREssuRE
155
(10.69
bar)
Fig. 1