EAS ELECTRIC EMF161 Guide D'utilisation page 32

5. CLEANING
5.1 Cleaning the interior and exterior of the unit
1. Remove all the shelves and the salad bin. To remove the salad bin first
remove the lower door shelf.
2. Wipe the inside of the unit with a weak solution of bicarbonate soda
and then rinse with warm water using a "wrung-out" sponge or cloth.
Wipe completely dry before replacing the shelves and salad bin.
3. Use a damp cloth to clean the exterior, and then wipe with a standard
furniture polish. Make sure that the door is closed to avoid the polish
getting on the magnetic door seal or inside the unit.
4. The grille of the condenser at the back of the unit and the adjacent
components can be vacuumed using a soft brush attachment.
5.1 Cleaning the interior and exterior of the unit
 Dust behind the refrigerator and the floor should be cleaned regularly to
improve the cooling effect and save energy.
 Check the door rubber regularly to make sure that there is no debris or
dirt left on the door. Wipe it with a damp cloth of soap and water or
diluted detergent.
 The inside of the refrigerator should be cleaned often to avoid odours.
 Disconnect the refrigerator from the power supply before cleaning the
interior, and remove all food, beverages, shelves and drawers, etc....
Use a soft cloth or sponge to wipe the inside of the refrigerator with a

solution of warm water and two tablespoons of baking soda. Then rinse
and wipe it with a cloth. After cleaning, open the door and allow it to air
dry before plugging it back in.
 For areas that are more difficult to clean (such as narrow slots, corners or
nooks and crannies), it is advisable to clean them often with a soft cloth or
brush and, if necessary, using other tools (such as a toothpick) to ensure
that contaminants and bacteria do not build up.
 Do not use soap, detergent, powders or sprays as these may cause odours
inside the refrigerator or contaminate food.
Clean the bottle rack frame, shelves and drawers with a soft cloth

dampened with soap and water or diluted detergent. Wipe dry with a soft
cloth or allow to air dry.
 Clean the outside surface of the refrigerator with a soft cloth dampened
with soap and water or detergent, then wipe dry with a cloth.
Do not use hard brushes, aluminium scouring pads, metal brushes,

abrasives (such as toothpaste), organic solvents (such as alcohol, acetone,
etc.), boiling water, acid or alkaline solutions, or anything else that may
damage the exterior or interior surface of the refrigerator. Boiling water or
organic solvents such as benzene may deform or damage plastic parts.
 Do not rinse directly with water or other liquids during cleaning to avoid
short circuits or affecting the electrical insulation by immersion.
14 V.2