Makita MU01 Manuel D'instruction page 8

Indication lamp
The lamp blinks in red
The lamp lights up inred.
(Note 1)
The lamp lights up in red.
(Note 1)
Note 1: The time at which the indication lamp lights up varies by the temperature
around the work area and the battery cartridge conditions.
010970
Adjusting the shearing height
2
010871
Changing the position of holding the change lever allows
three-stepped setting for sheared grass height (10 mm,
15 mm, 25 mm).
To change setting, tilt the change lever for the base frame
position and with the change lever tilted move it up or
down along the tool surface until the protrusion on base
frame fits in one of the holes in the tool and release it.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing blade cover
CAUTION:
Be careful not to contact the shear blade when
•
installing or removing the blade cover. Contacting
the shear blade may cause personal injuries.
This indicates the appropriate
time to replace the battery
cartridge when the battery
power becomes low.
This function works when the
battery power is almost used
up. At this time, tool stops
immediately
Autostop due to overload
1. Change lever
1
2. Protrusion on
base frame
3. Base frame
3
Status
Recharge the battery cartridge
as soon as possible
Recharge the battery cartridge.
Turn off the tool.
1
010869
010870
Slide the blade cover from the tool's side until the shear
blade completely hides itself and then push in it lightly
towards the tool from the front.
To remove the blade cover, take the above installation
procedure in reverse.
Installing or removing base frame
CAUTION:
Before installing or removing base frame, be sure
•
to install the blade cover.
When installing or removing base frame, take care
•
that your fingers are not be pinched between the
tool and base frame.
8
Action to be taken
1. Shear blades
2. Base frame
3. Blade cover
2
3