Makita MU01 Manuel D'instruction page 15

1
010892
Take out the undercover from the tool.
010893
Loosen two screws with a coin and similars and remove
the shear blades.
NOTE:
Do not remove the screws. Without removing the
•
screws loosened, shear blades can be removed.
1
2
010894
Remove the crank from the shear blades.
NOTE:
The crank may remain in the tool.
•
1
3
011045
NOTE:
In the 2-way usage, the removed grass shear
•
blades need to be sheared in the blade storage
case and stored for future use.
1. Undercover
1. Screws
1
1. Crank
2. Shear blades
1. Grass shear
blade cover
2
2. Grass shear
blade
3. Storage case
OPERATION
Refer to the Important Safety Instructions before
operation.
CAUTION:
Be careful not to accidentally contact a metal fence
•
or other hard objects while trimming. The blade will
break and may cause serious injury.
Also, be careful for the shear blade not to contact
•
the ground.
Overreaching with a hedge trimmer, particularly
•
from a ladder, is extremely dangerous. Do not work
from anything wobbly or infirm.
010878
Do not attempt to cut branches thicker than 10 mm
diameter with this trimmer. These should first be cut with
shears down to the hedge trimming level.
CAUTION:
Do not cut off dead trees or similar hard objects.
•
Failure to do so may damage the tool.
Do not trim the grass or weeds while using hedge
•
shear blade. The shear blade may entangle the
grass or weeds.
010879
Hold the trimmer with one hand, depress the lock-off
button and pull the switch trigger and then move it in
front of your body.
15