Makita MU01 Manuel D'instruction page 10

To install the grass shear blade, prepare the crank,
undercover and new grass shear blade
1
010896
Take out the blade cover from the old shear blades and
fit it onto the new ones for easy handling during the
replacement of blades.
1
1. Basic alignment line on the tool housing
2. Pins
010897
Adjust the three pin position so that these pins are lined
up at right angle in relation to the basic alignment line on
the tool housing.
1
2
010898
Fit the crank with its recessed part facing upwards onto
the pins. At this time, apply a small amount of grease to
the periphery of the crank using grease that the shear
blades as optional accessory are provided with or that
remains inside gear housing.
1. Blade cover
2. Shear blades
2
2
1. Recessed part of
crank
3
2. Pins
4
3. Crank
4. Apply grease
1
010899
Overlap the oval hole in the upper blade with that in the
lower one. Move the shear blades so that the hole in the
base plate of shear blades are positioned in the center of
these overlapped oval holes.
010900
Turn the shear blades upside down and install it so that
the pins on the tool fit in the hole in the shear blades.
Make sure that the shear blades are set in place
securely as far as they reach the base plate.
1
010901
Place the undercover so that the symbol
undercover is aligned with the symbol
lever.
010902
Press the undercover down and turn the undercover
clockwise while pressing it down until the symbol
the label is aligned with the symbol
lever (the undercover is completely locked.).
10
1. Base plate
2. Hole in the base
2
plate of shear
blades
3. Oval holes that
are overlapped
3
1. Undercover
2
2. Locking lever
on the locking
on the locking
on the
on