Maytag MDBH949PAW3 Instructions D'utilisation page 6

OPTIONS dish load types DESCRIPTIONS USE WITH:
ADDED
TIME TO
CYCLE
Tough fo0d Soils Adds heat and Wash time to the Jetc!ean® Plus Steam Normal, 30 min:
,, I cyc!e, I and Auto Clean
toueh
, , ,
Tough food soils Increases the target water Jetclean ® Plus Steam, Normal, 10 min.
,, temperature during the wash portions and Auto Clean
of the cycle. Adds heat, time, and water.
I _ I I
®
All loads Use for best drying results in Jetclean Plus Steam, Normal, 45 rain,
combination with rinse aid. Turn off Light Quick Wash and Auto Clean
when 10ads contain plastic I
d nnerware that may be sens t ve to
higher temperatures. _
To sanitize your dishes
and glassware
[]
Raises the water temperature in the
final rinse to approximately 154°F
(68°C). This high temperature rinse
sanitizes your dishes and glassware
in accordance with NSF/ANSI
Standard 184 for Residential
Dishwashers. Certified residential
dishwashers are not intended for
licensed food establishments. The
Sanitize option adds heat and time to
the cycle.
Jetclean ® Plus Steam, Normal,
and Auto Clean
30 min.
All loads When Control Lock is lit, all buttons All cycles
d_ are disabled. If you press any pad
[] while your dishwasher is locked, the
| light flashes. The door can be opened
i, oO, ro,
J
while the controls are locked.
CONTROL PURPOSE COMMENTS
To start or resume a If the door is opened during a CYcle or the power is interrupted, the START/RESUME
[] wash cyc!e indicator flashes. The cycle will not resume until the door is closed and START/RESUME is
pressed.
NOTE: If the START/RESUME button iS located ont0p of doorl puSh door firmiy clOSed
Within 3 seconds of pressing START/RESUME. If the door is not closed within 3 seconds,
the start button LED wil! flash, an audible tone wi!! be heard, and the cycle wi!! not start,
[]
Icancet I
To reset any cycle or
options during
selection.
To cancel a wash
cycle after it's
started.
Press CANCEL/DRAIN to reset any control selections made.
See "Canceling A Cycle" and "Changing A Cycle After Dishwasher Is Started" sections.
To tuin the audible Press and h01d the Hi Ternp Wash button foi 3 Seconds t0 turn the audible tones on or off.
[] tones on oroff. Only audible tones for confirming button presses can be turned on/off, Important audible
hi:m tones, such as ind cat ng a cycle has been interrupted, cannot be deactivated.
te p
w.sh NOTE: Audible tones are not available on all models.