First Use Or After A Long Period Of Disuse; Turning On The Appliance; General Operating Indications - Caffitaly System S07 Mode D'emploi

First use or after a long period of disuse

• Fit the used capsule drawer inside the drip tray and place in the machine (Fig. 15).
• Plug the power cord supplied into the relevant socket on the bottom of the appliance
(Fig. 16).
• Fill the tank with fresh, still water (Fig. 4).
• Plug in the appliance and turn it on (Fig. 13).
• Make sure the lever is closed (Fig. 3).
• As well as buttons A-B-C, indicator light D also blinks RED.
• Place a large container (at least 250 ml) under the dispensing spout (Fig. 9).
• Press one of the buttons A-B-C. Wait for the machine to complete the priming cycle and
fi ll with water. Indicator light D will switch off.
NOTE: if, at the end of the priming cycle, buttons A-B-C and indicator light D con-
tinue to blink, repeat the procedures as listed in the previous step.
• Buttons A-B-C will blink simultaneously to indicate that the machine is warming up.
• When buttons A-B-C turn on and remain steadily lit, perform a rinse by pressing button
C. Press the button again to perform a second rinse. Wait for the machine to complete
the rinse cycle.
• At the end of this operation, empty out the water from the used capsule drawer (Fig. 6).
• Fill the tank with fresh, still water (Fig. 4).
• Switch on the appliance by pressing the power on/off switch (Fig. 14).
• Buttons A-B-C will blink simultaneously to indicate that the machine is warming up. When
the buttons turn on and remain steadily lit, the appliance is ready for use.
DESCALING SIGNAL:
• When indicator light E blinks YELLOW and the machine beeps 3 times, a descaling cycle
should be carried out (see ch. Descaling).
HEATING:
• Buttons A-B-C blink simultaneously.
WHEN THE WATER RUNS OUT DURING OPERATION:
• The water tank is empty when indicator light D blinks RED and the appliance emits 3
beeps followed by a single intermittent beep.
• Fill the water tank with fresh, still water (Fig. 4).
• Press one of the buttons A-B-C. Wait for the machine to complete the priming cycle and
fi ll with water.
• When buttons A-B-C turn on and remain steadily lit, the appliance is ready for use.
IF THE LEVER IS RAISED WHILE DISPENSING:
• Raising the lever while dispensing a product (Fig. 1) may cause splashes of hot water.
Danger of scalding!
• Indicator light F blinks RED. The appliance will immediately stop dispensing.
• Close the lever (Fig. 3).
• Press one of the buttons A-B-C to reset the alarm.
• The appliance is ready for use again.
English

Turning on the appliance

General operating indications

11