First Use Or After A Long Period Of Disuse; Turning On The Appliance; General Operating Indications - Caffitaly System S18 Mode D'emploi

First use or after a long period of disuse

• Fill the tank with fresh, plain water (Fig. 4).
• Plug in the appliance and turn it on (Fig. 13).
• Make sure the lever is closed (Fig. 3).
• The buttons A-B-C blink together with alternate RED blinking of the indicator D.
• Place a large container (at least 250 ml) under the dispenser (Fig. 9).
• Press one of the buttons A-B-C. Wait for the machine to complete the water circuit fi lling
cycle. The indicator D goes off.
NB: If, after fi lling, the buttons A-B-C and the indicator D continue blinking, repeat
the operations of the previous point.
• Buttons A-B-C blink simultaneously; the machine is in the heating phase.
• When the buttons A-B-C light up steady, carry out the rinse by pressing the button C.
Press the button again to do another rinse. Wait for the machine to complete the rinse
cycle.
• At the end of this operation, empty the water from the used capsule drawer (Fig. 6).
• Fill the tank with fresh, plain water (Fig. 4).
• Switch on the appliance by pressing the main switch (Fig. 14).
• Buttons A-B-C blink simultaneously; the machine is in the heating phase. When the
buttons light up steady and 2 beeps sound, the appliance is ready to use.
DESCALING SIGNAL:
• When the indicator D blinks YELLOW, and 3 beeps sound, it is advisable to carry out the
descaling cycle (See the section Descaling).
HEATING:
• Buttons A-B-C blink simultaneously.
WHEN THE WATER FINISHES DURING OPERATION:
• When the indicator D blinks RED, and 3 initial beeps sound followed by 1 intermittent, the
water tank is empty.
• Fill the water tank with fresh, plain water (Fig. 4).
• Press one of the buttons A-B-C. Wait for the machine to complete the water circuit fi lling
cycle.
• When buttons A-B-C light up steady, the appliance is ready to use.
IF THE LEVER IS RAISED WHILE DISPENSING:
• Raising the lever while dispensing a product (Fig. 1) may cause splashes of hot water.
Danger of scalding!
• The indicator D blinks RED and an intermittent beep sounds. The appliance will
immediately stop dispensing.
• Close the lever (Fig. 3).
• Press one of the buttons A-B-C to reset the alarm.
• The appliance is ready for use again.
English

Turning on the appliance

General operating indications

11