Yamaha RX-V483 Guide De Démarrage Rapide page 14

7
Connecting the unit to a network
Connecting the unit to a wireless network
• The unit can be connected to a wireless network using the MusicCast
CONTROLLER app* installed on your smartphone or other mobile device.
A
Follow procedure .
• If a mobile device will not be used, follow procedure
to a wireless router (access point) that supports WPS. Refer to the Owner's
Manual for details on other wireless connection methods.
Connecting the unit to a router via a network cable
A
• Follow procedure to use the MusicCast CONTROLLER app* installed on
your smartphone or other mobile device to connect to the MusicCast
network to play music over a network.
• If a mobile device will not be used, skip this step and proceed to step
* MusicCast CONTROLLER, an app for mobile devices, can be used to
easily configure network settings for not only this unit, but also for other
MusicCast-enabled devices. This app allows you to listen to music stored
on your smartphone or other mobile device, or on servers, and to listen to
Internet radio stations. It also allows you to play this rich variety of music
content on all devices in the MusicCast network at the same time.
Visit the following website for details.
http://www.yamaha.com/musiccast/
14
En
A
B
to connect the unit
Connect the unit to a network and register it as a MusicCast-enabled device.
Note
• Confirm that your mobile device is connected to your home router before beginning.
• You will need the router's SSID and security key to connect the unit to a wireless
network.
• The MusicCast CONTROLLER app screens in this section show the English
interface. The screen appearance may vary depending on the app version.
8
.
1
Install the MusicCast CONTROLLER app
your mobile device, and open the app.
Search for "MusicCast CONTROLLER" on the App Store or Google Play.
2
Tap "Setup".
Connecting with the MusicCast
CONTROLLER app
on