Black & Decker BD200TMT Manuel D'instructions page 8

Universal Adaptor kit
An accessory adapter kit is provided with BD200MT. The
adapter is compatible with many manufacturers' accessories,
but if unsure, confirm with the specific manufacturer that their
accessory is compatible.
CAUTION:
To avoid injury, do not use any accessory
for an application where the adaptor may fail to hold the
accessory.
CAUTION:
Read and follow all manufacturers' safety
warnings for any accessories used with this tool.
CAUTION:
To avoid injury, ensure adapter and
accessory are securely tightened.
CAUTION:
Do not use this adaptor with Black and
Decker accessories. Attach Black and Decker accessories
with the tool-free release (G) according to the instructions in
this instruction manual.
• To attach, place adaptor plate (H) onto the oscillating tool
attachment with protrusions facing up as shown in figure 4.
• Place accessory on top of adaptor plate and fasten with the
bolt (E), press board (I) and o-ring (J). Then, tighten with the
hex wrench as shown in figure 5.
• To remove, loosen the bolt and washer with the hex wrench, then remove the
accessory and adapter.
Installing/Removing Accessories (BD200TMT
& BD200MT)
• Some accessories, such as scrapers and blades can be
mounted at an angle if required as shown in figure 6.
• A triangle shaped base, or platen, uses a hook and loop
adhesion system to attach the sanding sheets.
• Clean any residual debris from the tool shaft and the
accessory holder.
• Position the accessory so the working edge is away
from the tool as shown in figure 7.
• Place the sanding platen on the front of the
oscillating tool, ensuring the accessory fully engages
the pins as described under "Assembly."
• Align the edges on the sanding sheet, with the edge
of the sanding platen and press the sanding sheet
onto the platen as shown in figure 7.
• Firmly press the base with the sanding sheet
attached against a flat surface and briefly switch the
tool on. This provides for good adhesion between
the platen and the sanding sheet and also helps to
prevent premature wear.
• When the tip of the sanding sheet becomes worn,
detach the sheet from the platen, rotate and reapply
as shown in figure 7.
8
4
h
Protrusion
5
J
e
6
7
I