HQ Power VDSABS12A Mode D'emploi page 4


Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
crash, etc. Using the device in an unauthorised way will void the warranty.
4. Installation

Install the device in a location where few people pass by and that is unreachable for unauthorised persons.

Make sure there is no flammable material within a 50cm radius of the device.
5. Overview
Refer to the illustrations on page 2 of this manual.
1 Power input jack
Power button "1" on and "0" off
2
3 Line output XLR jack balance +4dB
Line output ¼" jack +4dB
4
5 Line input jacks, can receive both balance and unbalance signals
6 RCA (R.L) input jack, can receive both balance and unbalance signals
Microphone ¼" input jacks, can receive unbalance signals
7
8 Microphone XLR input jack, can receive balance signals
9 Volume control of MIC input
10 Volume control of RCA line input
11 Adjusts the output level or volume
12 Hi tone level control, 12dB raising attenuation at 3.5 KHz
13 Low tone level control, 12dB raising attenuation at 100Hz
14 Input signal overload indicator
6. Operation
Refer to the illustrations on page 2 of this manual.
Make sure the power switch is set to "OFF".

Set the power switch to "ON". The device starts operating.

Set the power switch to "OFF" to stop the device.

7. Cleaning and maintenance

All screws should be tightened and free of corrosion.

The housing, visible parts, mounting supports and the installation location (e.g. ceiling, suspension,
trussing) should not be deformed, modified or tampered with e.g. do not drill extra holes in mounting
supports, do not change the location of the connections.

The electric power supply cables must not show any damage. Have a qualified technician maintain the
device.

Disconnect the device from the mains prior to maintenance activities.

Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.

There are no user-serviceable parts.

Contact your dealer for spare parts if necessary.
8. Technical Specifications
woofer size
tweeter size
impedance
amplifier
power supply
frequency response
sensitivity (1W/1m)
dimensions
weight
V. 02 – 13/05/2013
VDSABS12A
12" (31cm)
1.35" (3.5cm)
8 ohm
150W (100Wrms)
230Vac
45Hz ~ 18kHz
95dB
630 x 410 x 330mm
23kg
4 ©Velleman nv