Dräger Interlock 7500 DVI Mode D'emploi page 25

5.3.7 Standby times
This function can be used to set and display the wake-up time. This function can
be used to shorten the start-up time at temperatures below 0°C (32°F).
5.3.8 Date & Time
This function displays the date and time.
5.4 Unlocking the instrument
The unlock code can be used to start the vehicle by delivering a breath sample
in the event of an instrument lockout (for example because of expiry of the
service period due to legal requirements), after entering a code number.
1. To obtain the code number, call the service phone number and have the
following information ready:
● serial number of the handset,
● date and time (hours and minutes) at which the code number has to be
entered.
The code number is accepted for a period of up to 15 minutes after
the specified time.
2. Choose and confirm the Unlock device option. The display shows _ _ _ _.
3. Select and confirm the desired first figure.
4. Afterwards set the next figure.
5. Repeat the procedure for all figures.
6. Select Confirm or Cancel:
● Pressing cancel will exit the menu.
● On confirmation, the instrument will request a breath alcohol test.
5.5 Access code
The access code can be used to start the vehicle without delivering a breath
sample, for example in a garage, for a limited period after entering a code
number.
1. To obtain the code number, call the service phone number and have the
following information ready:
Instructions for use |
Dräger Interlock
2. Choose and confirm the Enter code: option. The display shows _ _ _ _.
3. Select and confirm the desired first figure.
4. Afterwards set the next figure.
5. Repeat the procedure for all figures.
6. Select Confirm or Cancel:
5.6
5.6.1
This function can be used to set the brightness of the display. There are 3
preset brightness levels to choose from.
5.6.2
This function can be used to change the instrument language.
5.6.3
This function can be used to switch communication between Bluetooth and
infra-red channels.
®
7500 DVI
● serial number of the handset,
● date and time (hours and minutes) at which the code number has to be
entered.
The hour entered indicates how long the access code is valid for.
Example: When it shows 14:00 the access code can be used from 14:00 to
14:59.
Access is (depending on setting) possible for a maximum of 48 hours after
entering the code number.
● Pressing cancel will exit the menu.
The validity of the access code can be terminated by requesting a new
breath alcohol test (see "Breath test", page 24).
Configuration
Display
Language
Communication
|
Menu
25