Schumacher Electric RED FUEL SL3 Série Guide D'utilisation page 5

4. CHARGING YOUR ELECTRONIC DEVICE
Charging times will vary.
The Fuel Pack is pre-charged at 50-60% capacity, and
should be ready to use upon purchase. Charging to
full capacity is recommended before first use.
NOTE: When charging iDevices, use the charging cable
included with your iDevice. If the lightning connector
end is unplugged during charging and the fuel pack
shuts off, you must disconnect and reconnect both ends
of the charging cable, to resume charging.
Battery Reset
If the battery needs to be reset for any reason, simply
reconnect the fuel pack to your laptop or computer.
SL3 series
1. iDevices: Plug the iDevice charging cable's end
into your iDevice's input port.
Other devices: Plug the Micro USB end of the
(provided) charging cable into your device's input port.
2. Plug the USB end of the charging cable into the
Fuel Pack's "OUT" USB port.
3. The device should show the charging icon.
SL4 series
iDevices
1. Plug the iDevice charging cable's end into your
iDevice input port.
2. Plug the USB end of the charging cable into either
the Fuel Pack's "5V/1A" or "5V/2A" port.
("5V/2A" is recommended for iPad.)
3. Push the Power Level button on the side of the
Fuel Pack (near "5V/2A" port) to check the capacity
level of the Fuel Pack.
• 5 •