Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
STANDARD ACCESSORIES
Fig. 3
WARNING:
PREPARATION BEFORE OPERATION
Make the following preparations before operating the power tool:
1. Installation
The machine may be bolted (2 bolts) down to a level location using the bolt holes in the base.
2. Extension Cord.
Ampere rating
(on nameplate)
Ext. cord length
25 ft
(7.5 m)
50 ft.
(15 m)
100 ft.
(30.5 m)
NOTE: The lower the wire size number, the heavier the wire, and the farther it will carry current
without a voltage drop.
WARNING:
3. Take off the chain.
As the movable part is pulled down by a chain when shipping out, slightly push the handle
down and take off the chain from the handle.
Cut-Off Wheel 14" × 7/64" × 1"(355 × 2.8 × 25.4 mm)
1pc. (Code No.)
(Attached to the main body)
Hex. bar wrench
The use of attachment or accessories not recommended in this
manual or accessories for uses not recommended for this tool can
be dangerous and could cause serious injury or mechanical damage.
12.1 to 16.0
Wire gauge size
A.W.G (mm
)
2
14 A.W.G
(2.0 mm
)
2
12 A.W.G
(3.5 mm
)
2
Not
recommended
Never connect this unit to an electrical power source until all
operating instructions have been read and understood.
To use the power tool when no suitable power
source is nearby, use an extension cord of suitable
size to ensure safety, and to prevent power loss and
overheating.
Determine from the accompanying table the
required extension cord wire size.
Check power cord and extension cords for loose
or exposed wires and damaged insulation, before
using.
Repair or replace as needed, before using the
power tool.
English
9
Publicité
Table des Matières
