Before Using - Metabo HPT CC 14SF Instructions De Sécurité Et Mode D'emploi

English

BEFORE USING

1. Make sure the power source is appropriate for the tool.
WARNING:
2. Make sure the trigger switch is turned OFF.
WARNING:
3. Check the cut-off wheel for visible defects.
Confi rm that the cut-off wheel is free of cracks or other visible damages.
4. Confi rm that the cut-off wheel is fi xed securely to the power tool.
Using the supplied hex. bar wrench, tighten the clamping bolt on the cut-off wheel mounting
shaft to secure the cut-off wheel.
WARNING:
5. Check the sub cover (A) for proper operation.
Possible accidents such as a cracked out-off wheel is prevented by this sub cover (A) (wheel
cover).
Although it has been fully clamped at the factory prior to delivery, securely reclamp the
mounting screws for safety.
Sub cover (A) and wheel cover are designed to protect the operator from coming into contact
with the cut off wheel during operation of the tool.
WARNING:
6. Use cut-off wheels whose peripheral speed ratings are over the maximum working
peripheral speed.
When replacing the cut-off wheel, ensure that the replacement cut-off wheel has a designed
peripheral speed in excess of 16,000 ft/min (4,800m/min).
WARNING:
7. Confi rm the stopper position.
Confi rm that the stopper which was used for installtion and removal of the cut-off wheel has
returned to the retract position.
8. Securely fi x the cutting material.
Ensure that the material is securely fastened with the vise. If it is not, a serious accident
could be caused if the material comes loose or the cut-off wheel breaks during operation.
10
Never connect the power tool unless the available AC power
source is of the same voltage as that specifi ed on the nameplate
of the tool.
If the power cord is connected to the power source with the
trigger switch turned ON, the power tool will start suddenly and
could cause a serious accident.
When the clamping bolt is loose, the cut-off wheel may be
damaged when the wheel axle starts revolving, causing a
hazardous condition.
NEVER OPERATE THE POWER TOOL if the safety covers do not
function smoothly.
Never use cut-off wheels whose peripheral speed ratings are
under the maximum working peripheral speed.