Busch+Müller TOPLIGHT Dart E Brex Notice D'utilisation page 16

7. Power supply
Rear light exclusively for connection to a DC voltage source of 6 to 50V (
Connection to an AC voltage source (e.g. dynamo) is not permitted!
Cable with open strands:
1. Pull off the attached cable clamp
2. Push the cable with the ends stripped by approx. 5 mm through the insertion holes of the cable clamp.
Bend the open strands downwards around the cable clamp so that they are fixed and do not touch
each other. do not touch each other. Make sure the polarity is correct!
3. Insert the cable clamp with the cables into the tail light so that the open strands are guided to the plug
contacts of the tail light. the plug contacts of the tail light and fix them there.
Cable with cable lugs:
1. Pull off the attached cable clamp
2. Attach the cable to the plug contacts. Make sure the polarity is correct.
3. The cable clamp is no longer needed.
The connection of this rear light is only permitted on vehicles where it is ensured that after the battery
has been switched off due to discharge, power is still available to supply the lighting system for at least
2 hours.
16
1 .
1 .
), e.g. e-bike battery.
AC DC