Busch+Müller TOPLIGHT Dart E Brex Notice D'utilisation page 14

5. Package content
Rear light with assembly bolts | Fastening nuts | Instruction Manual
6. Assembly
Attach the rear light to the rack using the two fastening bolts on the rear and the enclosed fastening
material. The rear light is designed for a 50 mm or 80 mm assembly dimension. Tighten the screws
only to the extent preventing the rear light from slipping or falling off. BREX works without electrical
connection to the brake lever.
!
Align the rear light so that it is perpendicular to the ground and parallel to the colour track as shown
in the sketch opposite. This is absolutely necessary for the correct function of the stoplight!
No overhead mounting: Le feu arrière ne doit pas être monté à l'envers !
Important: Lighting equipment must not be concealed at any time.
14