Westinghouse QK0312 Manuel De L'utilisateur page 8

Installation (continued)
INSTALLING THE SINK
NOTE:
Install the faucet according to the manufacturers instructions before this step.
Install the vanishing edge strainer according to the instructions before completing this step. See page 11.
TM
- Put the threaded inserts on the bolts of the undermount clips (E) loosely in the holes that you drilled for them in the underside of
the counter . Ensure that the clamps of the undermount clips (E) are turned so that they do not interfere with the placement of the
sink .
- Place a small bead of silicone sealant (not included) around the upper lip of the sink (A) .
- Carefully place the sink (A) into its location under the counter, lining up the pencil
marks on the lip of the sink that you made when you tested the fit of the sink.
- Carefully rotate the clamps of the undermount clips (E) over the clamp bar on the sink (A) and gently tighten the bolts (see
tightening sequence) of the undermount clips (E), working from side to side to fasten the sink (A) firmly. Recheck the alignment
visually from above .
- Wipe away any excess silicone and, for best results, allow the bond to rest undisturbed for 8 hours or overnight .
- Install the counter as directed by the manufacturer and install all other plumbing as required .
E
SUPPLY LINES (NOT INCLUDED)
The supply lines, which connect the faucet to the household water system, are not supplied with this unit . They need to be purchased separately .
Follow the supply line manufacturer's instructions for proper installation .
A
8
6 2 4
9
10
3 5 1
Tightening sequence for clips
7
8