Westinghouse QK0312 Manuel De L'utilisateur page 11

Installation (continued)
INSTALLING THE VANISHING EDGE
NOTE:
If you are installing a garbage disposer (not supplied), do not install the strainer.
You will need to purchase from Conglom Kitchen & Bath, an adaptor. This will replace
the flange from your garbage disposer.
Install the garbage disposer according to the manufacturer's installation instructions
replacing the flange for the adaptor.
- Apply a small amount of plumber's putty (not included) in the notch around
the drain hole of the sink .
- Connect the upper strainer body (C2) and the strainer ring (C3), and insert
them into the drain hole from the top of the sink .
- Connect the strainer gasket (C4) and lower strainer body (C5), and insert
them into the drain hole from underneath the sink .
- Insert the strainer screw (C1) through the entire assembly, from the upper
strainer body (C2) to the lower strainer body (C5). Tighten with a flathead
screwdriver .
- Connect the plastic flange (1) and tail pipe (2), and thread the connecting
nut (3) through the tail pipe and flange up to the lower strainer body (C5).
Lock the connecting nut by hand .
NOTE:
The plastic flange (1), tail pipe (2), and connecting nut (3) are not supplied.
INSTALLING THE BOTTOM GRID
- Ensure that the vanishing edge
(A) before placing the bottom grid (F) .
- The bottom grid (F) must be positioned with the rubber supports down .
Tilt the grid up so it is at a slight angle, slide it into the sink (A), and place
it so that it is sitting flat on the bottom of the sink.
STRAINER
TM
strainer basket (B) is already in the sink
TM
Please contact customer .service@conglomkb .com or 1-877-333-0098 for further assistance .
A
11
B
C1
C2
C3
C4
C5
1 Not supplied
2
3 Not supplied
B
F
CONGLOMKB .COM