Publicité
Les langues disponibles
Les langues disponibles
Installation
UNDERMOUNT INSTALLATION
PREPARING THE AREA
NOTE:
Undermount sinks are mounted from below the counter. If you
are installing a topmount or "drop-in" sink, please see "topmount
installation" on page 9.
It is highly recommended that undermounting be performed by a
professional installer. Improper installation will void the warranty.
- Remove the undermount sink template (1A) from the box .
NOTE:
Your faucet and accessory (if applicable) will be installed onto the
sink deck.
- Place the template (1A) on the desired counter space
surface . Keep in mind that the typical setback is
3 1/2 - 4 in . (89 mm - 102 mm) from the front of the
counter (depending on the cabinet structure, the counter
overhang, the type of sink bowl, and the deck size).
- Make sure the template (1A) is parallel to the front of the
counter .
1A
Faucet will be installed on sink deck
CUTTING THE COUNTER
CAUTION: Always wear safety goggles and gloves when
using power tools to prevent personal injury .
- Ensure that the template (1A) is placed so that the sink
will clear all objects and the mounting hardware can be
installed . Make sure there is a minimum of 3 in . (76 .2 mm)
of space underneath on all four sides for the undermount
clips (E) .
- Place a line of tape around the template .
- Use a saber-saw or jig-saw to cut along the cut line . Place
a support underneath the cut-out portion of the counter to
prevent it from falling during cutting .
3 1/2 - 4 in.
(89 mm - 102 mm)
Tape
6
Publicité
