Westinghouse QK0312 Manuel De L'utilisateur page 7

Installation (continued)
DRILLING THE HOLES FOR THE
UNDERMOUNT CLIPS
CAUTION: Always wear safety goggles and gloves when
using power tools to prevent personal injury .
- On the underside of the counter, mark the location of the ten
holes (5) for the undermount clips (E) . These holes should be
equally spaced around the perimeter of the cut-out with three on
each side 2 and 4 and two on each side 1 and 3 . They should be
set back from the cut-out opening by 1 1/2 in . (38 mm) .
- Using an electric drill with a 3/8 in . (10 mm) drill bit, drill each
hole so that it is 3/8 in . (10 mm) in diameter and 5/8 in . (15 .8
mm) deep .
1
5
2
TESTING THE FIT OF THE SINK
- Place the sink (A) underneath the cut-out in the counter to
- When you are satisfied with the location of the sink (A), mark
4
3
7
Please contact customer .service@conglomkb .com or 1-877-333-0098 for further assistance .
test its fit. Ensure that the reveal is equal on all four sides
when viewed from above . Make adjustments to the cut-out if
necessary .
the location of the edge of the counter cut-out on at least
two sides of the lip of the sink .
A
CONGLOMKB .COM