Filling With Water; Overtemperature Protection; Polymerization; Selecting The Temperature Stage - Heraeus Palamat elite Mode D'emploi

7.2

Filling with water

The unit must not be heated without water. Minimum filling level: 4 cm. Even if objects are placed in,
the filling level is always below the upper end of the air supply fitting. Do not fill the unit under running water.
Prior to filling with water, check if the water discharge valve at the rear of the unit is closed.
Use only pure tap water for processing.
Distilled, deionized water or other liquids may not be used!
GB

7.2.1 Overtemperature protection

- 8 -
The Palamat elite unit is equipped with two overtemperature protections which are activated if the temperature
is exceeded by 110°C (230°F).
In the event of activation of the fuses, the heating circuit is interrupted.
Please check your minimum filling level.
Note!
The overtemperature protections may only be reset by trained service personnel.
Contact your responsible service agent (see chapter 11 Service).
7.3

Polymerization

To switch on the unit, press the power switch (5) at the front of the unit. The power switch is lit and indicates that the unit has
been started up. The software version is shown in the Timer Display (15) for a short period.

7.3.1 Selecting the temperature stage

The yellow LED indicates the currently selected temperature program.
The select-key is used for selecting prior to the polymerization process.
The select-key is deactivated during the process.
Additionally, the blinking pattern of the LED indicates the current temperature status.
Selection of stage
55°C (131°F)
90°C (194°F)
100°C (212°F)
70°C – 100°C
(158°F – 212°F)
*) The Kulzer water bath features a fixed temperature ramp (see Heraeus Kulzer materials):
➜
70°C (158°F)
75% 25%
100%
75% 25%
Polymerization Standby
type Temperatur
Cold polymerization 55°C (131°F)
Hot polymerization 90°C (194°F)
Hot polymerization 100°C (212°F)
Hot polymerization 70°C (158°F)
(Kulzer water bath)
➜
residence time 90 min heating up to 100°C (212°F) within 30 min
Heating.
LED is deactivated shortly
Temperature is reached.
LED is permanently lit
Cooling down.
LED is activated shortly
Process Pressurization
temperature
55°C (131°F) automatic
90°C (194°F) automatic
100°C (212°F) manually
70°C – 100°C manually
(158°F – 212°F)
➜
Timer
freely editable
freely editable
freely editable
automatic preset *)
residence time 30 min.