Tunturi 19TRN80000 Manuel D'assemblage page 16

English
Safety key (Fig F-4)
The equipment is equipped with a safety key that
must be properly inserted into the console to start
the equipment. If your safety key is pulled out
partly it will activate the emergency mode and will
have the equipment stop immediately.
- Insert the safety key into the slot in the console
by pressing in it inwards.
- Make sure that the clip of the safety key is
properly attached to your clothing.
Make sure the clip attached to your clothing
is attached firm enough so it can pull out the
safety key when needed.
‼ NOTE
• The safety key cannot be removed from the
unit, as it is a fixed structure.
‼ NOTE
• Console will show E7 code when safety key
is not in (correct) position during start up.
Circuit breaker (Fig� E-2B)
The equipment is equipped with a circuit breaker
that interrupts the circuit when the electricity load
is above the maximum capacity. When this occurs,
the circuit breaker must be pressed.
⚠ WARNING
• Before pressing the circuit breaker, remove
the mains plug from the equipment.
If the equipment shuts down, proceed as follows
to restart the equipment:
- Remove the mains plug from the equipment.
- Press the circuit breaker to restart the
equipment.
- Insert the mains plug into the equipment.
‼ NOTE
• Some circuit breakers used in homes are
not rated for high inrush currents that can
occur when a treadmill is first turned on or
even during normal use. If your treadmill is
tripping the circuit breaker (even though it is
the proper current rating and the treadmill
is the only appliance on the circuit) but
the circuit breaker on the treadmill itself
does not trip, you will need to replace the
breaker with a high inrush type. This is not a
warranty defect. This is a condition we as a
manufacture have no ability to control.
16
Unfolding and folding the
equipment (fig� F1-F2)
The equipment can be unfolded for use (fig. F1)
and folded for transport and storage (fig. F2).
Refer to the illustrations for the correct way of
unfolding and folding the equipment.
⚠ CAUTION
• Before folding the equipment, make sure
that the incline is 0. If the incline is not 0,
folding will damage the mechanism.
Adjusting the support feet
The equipment is equipped with 4 support feet. If
the equipment is not stable, the support feet can
be adjusted.
- Turn the support feet as required to put the
equipment in a stable position.
- Tighten the locknuts to lock the support feet.
‼ NOTE
• The machine is the most stable when all
support feet are turned fully in. Therefore
start to level the machine by turning all
support feet fully in, before turning out the
required support feet to stable the machine.
Warranty
Warranty terms
The consumer is entitled to the applicable legal
rights stated in the national legislation concerning
the commerce of consumer goods. This warranty
does not restrict these rights. The Purchaser's
Warranty is only valid if the item is used in an
environment approved by Tunturi New Fitness BV
for that particular equipment. The product-specific
approved environment is stated in the Owner's
Manual provided with your equipment.
Additional information
Packaging disposal
Government guidelines ask that we reduce the
amount of waste material disposed of in land fill
sites. We therefore ask that you dispose of all
packaging waste responsibly at public recycling
centres.