Whirlpool ZET1 Instructions D'installation page 8

Cabinetry
r_ Single Oven Cutout
for Installation Below
a Monogram Advantium
Oven
Single Oven Cutout
for Installation Between
a Monogram Advantium
Oven and a Monogram
Warming Drawer
3" (7.6 cm) Min.
Note: Install the
oven only with
specific models
listed on the label
located on top of
the oven.
Per Advantium
Requirement
3" (7.6 cm) Min.
2" (5.1 cm) Min.
NOTE: The middle rail separating the two
openings may need to be larger than the 3"
(7.6 cm) minimum shown. Always refer to the
individual installation instructions packed with
each product for specific requirements.
Combined Advantium and Wall
Oven Installation:
When installed in combination with a
Monogram single wall oven, use separate
electrical junction boxes.
• Refer to the Advantium oven installation
instructions for electrical requirements of
that product.
• These connections must be made
by a qualified electrician. All electrical
connections must meet National Electrical
Code or prevailing local codes.
Per Warming Drawer
Requirement
NOTE: Additional clearances may be
required. Check to be sure the oven
supports above the Warming Drawer
do not obstruct the required interior depth
and height. The middle rail separating the
openings may need to be larger than the
2" (5.1 cm) minimum shown. Always refer to
the individual installation instructions packed
with each product for specific requirements.
Warming Drawer
Combined with Advantium
and Single Oven:
Install a separate 120V, 60Hz, properly
grounded receptacle. See installation
instructions packed with each product
for specific requirements.