Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
lcl Securing the Oven in the Opening
I_
Sliding the Oven Into
the Opening
a. Loop (do not tie) a 36" (91 cm) string
around the conduit
before the oven is slid
into place. This will keep the conduit from
falling behind the oven.
Pull out on
string loop
while pushing
the oven into
the cabinet
b. Lift oven into cabinet cutout using the oven
opening
as a grip. Carefully
push against
oven front frame. Do not push against
outside
edges.
c. As you slide the oven back, pull the string
so that the conduit will lie on top of the
oven in a natural loop.
d. When you are sure the conduit
is out of the
way, slide the oven 3/4 way back into the
opening.
Remove
the string by pulling on
one end of the loop.
Drilling the Pilot Holes
and Mounting the Oven
i
a,
NOTE: Before drilling the pilot holes,
make sure the oven is pushed as far
back into the opening
as it will go
and centered.
i
Drill through the mounting
holes (top and
bottom) of the side trim, for the #8 screws
provided.
Mounting
Hole
Locations
(Hole
Locations
may vary)
The screws must
be a minimum
of
1/4" (0.64 cm)
from the front
of the cutout.
WARNING:
Mounting
screws must be used. Failure to
do so could result in the oven
falling
out of the cabinet causing
serious injury.
=
b. Secure the oven to cabinet with screws
provided.
NOTE: If the cabinet
is particle board, you
must use #8 x 3/4" (1.9 cm) particle board
screws. These may be purchased
at any
hardware
store.
11
Publicité
