Whirlpool ZET1 Instructions D'installation page 4

Installation Instructions
Cutout for Single Built-In Oven
Allow 11/16" --_
(1,76 cm) for
overlap of oven
over side edges
of cutout
Cutout Width ,_ 3/4" Junction Box
28 1/2" Min, 4- Location
_-28 6/8" Max.-_ (19.7 cm) (junction box
(72.4 to 72.7 cm) IMax. may be
located in
adjacent
j cabinet)
Opening
Between
Inside Walls
Must Be
At Least
28 1/2"
Allow 1" (2,6 cm)
minimum for
overlap of oven
top and 1V4"
(3.2 cm) overlap
of oven bottom
of cutout
Cabinet
Width
30" (76.2 cm)
(63.3 c _
Allow a minimum
of 21" {53.3 cm) for
clearance to adjacent
corners, drawers,
walls, etc. when
door is open
Height
27 1/4" Min.
27 6/16" Max,
(69.2 to 69.4 cm
!
22" (56.9 cm) Min.
to Bottom of
Junction Box
Cabinet Width
Recommended
Cutout Location
from Floor
Cutout Depth
Cutout Width
Cutout Height
30" (76.2 cm)
32 1/2" (82.6 cm)
23 1/2" (59.7 cm) Min.
28 1/2" (72.4 cm) Min.
28 5/8" (72.7 cm) Max.
27 1/4" (69.2 cm) Min.
27 5/16" (69.4 cm) Max.
Recommended
cutout location from
floor 32 1/2" (82.6 cm)
NOTE: If the cabinet does
not have a front frame and
the sides are less than 3/4"
(1.9 cm) thick, shim both
sides equally to establish
the cutout width.
If the cabinet does not have a solid bottom,
two braces or runners must be installed
level with the bottom of the cutout to
support the weight of the oven. For single
ovens, the runners and braces must
support 200 Ibs. (90 kg).
NOTE: If marks, blemishes or the
cutout opening are visible above the
installed oven, it may be necessary to
add wood shims under the runners and
front trim until the marks or opening
are covered.
Side by Side Installations
Install two wall ovens in separate cutouts.
Allow 2" (5.1 cm) min. between cutouts
(ZET1R models) or 6" (15.2 cm) min.
between cutouts (ZET1P, S models).
Cutout- 2" (5.1 cm) Cutout - I
Observe all Min. (ZET1R=) Observe all I
dimensions _ or v dimensions I
and 6" (15.2 cm) and
requ rements. Min. (ZET1P,S) requ rements.
Suitable
Bracing
to Support
Runners
1--
21 618" --_
(54.9 cm)
Over Centerline
of Cabinet
Install a
solid bottom
or 2" x4"
(5cmx 10cm)
or equivalent
runners level
with bottom
of cutout
The solid bottom or runners must be level
with the bottom of the cutout, or the bottom
trim may not install correctly and then
interfere with the door opening.
This oven is not approved for
stackable installation.