Whirlpool ZET1 Instructions D'installation page 5

Installation Instructions
Cutout for Double Built-In Oven
Allow 11/t6" --_
(1.8 cm) for
overlap of oven
over side edges
of cutout
Allow a minimum
of 21" (53.3 cm) for
clearance to adjacent
corners, drawers,
walls, etc. when
door is open
Cutout
Width
28 1/2"
(72.4 cm) Min.
28 5/8" __
(72.7 cm) Max.
<_'Opening -_1
Between
Inside Walls
Must Be
At Least
28 1/2"
(72.4 cm) Cutout
Wide Height
51 13116"
Allow 1" (2.5 cn (131.6 cm) Min.
minimum for 51 15116"
overlap of oven (131.8 cm) Max
top and 11/4"
(3,2 cm) overlap
of oven bottom
of cutout ]
Recommended cutout
30"_t location from floor
(76.2 cm_)_T = 12" (30.5 cm)
Cabinet
Width
7 314"
(19.7 cm)
Max.
/
I
I
T
I
Junction Box
Location
/
If the cabinet does not have a solid bottom,
two braces or runners must be installed
level with the bottom of the cutout to
Suitable
support the weight of the oven. For double
Bracing
ovens, the runners and braces must to
Support
support 375 Ibs. (169 kg). Runners
- -
Cabinet Width 30" (76.2 cm)
NOTE: If marks, blemishes or the
cutout opening are visible above the
installed oven, it may be necessary to
add wood shims under the runners and
front trim until the marks or opening
are covered.
Recommended
Cutout
Location
from Floor
Cutout Depth
CutoutWidth
12" (30.6 cm)
23 1/2" (69.7 cm) Min.
28 1/2" (72.4 cm) Min.
28 6/8" (72.7 cm) Max.
47" (119.4
cm)
Min.
Cutout Height 51 13116" (131.6 cm) Min.
to Bottom of
Junction B ox 51 15/16" (131.8 cm) Max.
NOTE: If the cabinet does
not have a front frame and the
sides are less than 3/4" (1.9 cm)
thick, shim both sides equally
to establish the cutout width.
.1=
-F--_( 21s/8"------t-
54,9 cm) /
Over Centerline
of Cabinet
Install a
solid bottom
or 2"x4"
(5cmx 10cm)
or equivalent
runners level
with bottom
of cutout
The solid bottom or runners must be level
with the bottom of the cutout, or the bottom
trim may not install correctly and then
interfere with the door opening.