Whirlpool ZET1 Instructions D'installation page 7

Cabinetry
Single Oven Cutout
for Installation Over
a Monogram Warming
Drawer
Double Oven Cutout
for Installation Over
a Monogram Warming
Drawer
Per Warming
Drawer
Requirement
Anti-Tip Block Against
Rear Wall Per Warming
Drawer Requirement
2" (5.1 cm) Min.
NOTE: install the
oven only with
specific models
listed on the label
located on top of Per Warming
the oven. Drawer
Requirement
Anti-Tip Block
Nnst Rear
Wall Per
Warming
Drawer
Requirement
2" (8,1 cm)
Min,
1" (2.8 cm) Min, Above Toekick or
Adjust to Oven Installation Height
NOTE: Additional clearances between cutouts
may be required. Check to be sure the oven
supports above the Warming Drawer location
do not obstruct the required interior depth and
height.
1" (2.5 cm) Min. Above Toekick
When installing a Monogram Warming
Drawer below a single or double oven, a
separate 120V, 60 Hz, properly grounded
receptacle must be installed. Refer to
installation instructions packed with the
Warming Drawer for specific installation
requirements.
Cutout for Frameless Cabinets
Frameless Cabinets
Whenever possible, order 30" (76.2 cm)
frameless cabinet with the cutout sided to fit
the oven. If using stock cabinets, additional
finished filler pieces may be required to
cover the opening.
• A stock frameless cabinet cutout width
may be up to 28 3/4" (73 cm). If necessary,
add 1/2" (1.3 cm) cleats to the sides, flush
with the front edge of the side panels to
accept mounting screws.
Install 1/2"
(1.3 cm)
Cleats to
Hold Oven
Mounting
Screws
Double
51 15/16" (131.8 cm
Single
27 5/16" (69.2 cm)
Cabinet Depth
23 1/2" (89.7 cm)
Min, From Inside
Back to Front of
Cabinet Frame
or Side Panel
314" (1,9 cm) Min.
Thick Bottom Shelf
Cut Back Flush
with Front of
Side Panel