Publicité
Les langues disponibles
Les langues disponibles
1. Cable tie
2. To main harness light kit connection
8.
Route the rest of the harness down the inside of the traction unit frame alongside the traction unit wire
harness as shown in
9.
Lift the back of the machine off the ground. Support the machine using jack stands.
Note:
Use jack stands rated for your machine.
WARNING
Mechanical or hydraulic jacks may fail to support the machine and cause serious injury.
Use jack stands when supporting the machine.
10.
Remove the bottom cover from the traction unit by removing the 2 bolts holding it in place
Figure
12.
Figure 11
3. To light kit connection
Figure 12
10
g355414
g352195
(Figure
13).
Publicité
