HQ Power MICW81 Mode D'emploi page 6

5. Powering Your System
5.1 Receiver
1. Make sure the receiver is switched off and the volume knob is at its minimum.
2. Connect the adapter to the receiver and plug it in the mains.
3. Switch on the receiver.
5.2 Microphone
When the low-battery indicator lights, the battery is low. Replace the batteries with new
ones.
1. Make sure the microphone is switched off.
2. Open the battery compartment by lifting the plastic cover.
3. Insert two new 1.5 V AA batteries in accordance with the polarity markings inside
the battery compartment. Do not use rechargeable batteries as these might
influence the performance.
4. Close the battery compartment and switch on the microphone.
•
Malfunction may occur if the power is on when the battery is replaced. Dispose of
batteries in accordance with local regulations.
•
Keep batteries away from children.
6. Operation
1. Pull out both antennas and place them perpendicular to the receiver.
2. Connect the receiver to the sound system:
3. Make sure the volume level is at its minimum and switch on the receiver.
4. Switch on the microphone.
5. Adjust the volume to a moderate level.
6. Turn the volume level to its minimum prior to switch off the receiver.
V. 04 – 25/06/2021
OUT MIX: Use an appropriate audio cable to connect to the amplifier or mixing
o
table.
BALANCE OUT: Use an appropriate audio cable to connect to the amplifier or
o
mixing table.
MICW81
WARNING
6 ©Velleman nv