Bartscher FTH - 30 Notice D'installation Et D'emploi page 5

• safety fuse of the feeder and inner mains can stand the loading of the device (see label of the matrix)
• mains are equipped with effective grounding according to standards (ČSN) and conditions given by law
• socket or switch of the feed is well accessible from device
We refuse any responsibility in case of not respecting above mentioned rules. Before the fi rst use it is necessary
to remove all the protection foil and to clean the device - see chapter „cleaning and maintenance".
Before the fi rst use it is necessary to remove all the protection foil and to clean the device - see chapter „cleaning
and maintenance". We recommend you to leave the device empty when switching it on for the fi rst time. Switch
the device for the full power approx. for 15-20 min to burn the top.
INSTRUCTION FOR USE
Attention!
Before the fi rst use of the device wash the device with water containing detergent and than dry with the cleaning
cloth. Never leave the device on without supervision!!!
Drawer for superfl uous fat
You must check the drawer regularly and empty it in time. You must clean the drawer after each switching the
device off.
Comments and recommendation
The devices with separated surface into 2 halves (FT-60) can be adjusted for different temperatures on both of
the halves. You can also use only one half. Switch on by main switch (D), turn the knob (A) and adjust required
performance. Pilot lamps (B) and (C) will light. Pilot lamp (B) lights when the device is connected to the electricity.
Pilot lamp (C) lights when the heating spirals are on. Pilot lamp (C) goes out when the device reaches adjusted
temperature. Switch the device off by turning the knob (A) into position „0" and switch off the main switch (D).
Maintenance
We recommend to have the device checked once a year by the professional service. Only qualifi ed or competent
persons can do interventions in the product.
Comments and recommendation
Use the device only under supervision.
D
B
A
C
5