Publicité
Les langues disponibles
Les langues disponibles
Function
The radiator thermostat enables you to intelligently
control radiators. The device receives its commands
program-controlled via the central unit. You can also
adjust the desired temperature manually.
Hazard warning
• Do not open the radiator thermostat. It does not
contain any parts to be serviced by the user. If a
fault occurs, please contact our Customer Service.
• Avoid the influence of humidity, dust, sunlight and
other heat radiation.
• The radiator thermostat is only suitable for regu-
lating heaters (radiators, convectors, hot strips)
heated by heat carriers. Using it for other purposes
(e.g. on cooling systems, floor heaters etc.) is not
permitted and can lead to damage.
Commissioning
1 Disassemble the mechanical thermostat by turn-
ing it to the left as far as the limit stop. Remove the
thermostat from the valve.
2 Insert the batteries (type AA) into the battery com-
partment ensuring the correct polarity. Wait until
the pin is fully retracted and „A2" appears on the
display.
3 Now install the radiator thermostat. The radiator
thermostat fits all standard valves with a M30 × 1.5
mm connection thread. You will need adapters for
specific heater valves. Adapters for Danfoss valves
of the RAV, RA and RAVL series are included.
4 The radiator thermostat starts self-adjustment.
"A3" appears on the display. This procedure can
take up to three minutes. If the procedure is
aborted, "F2" appears on the display. You can
restart the procedure by pressing the control but-
ton.
5 Integrate the device via the search mode of the
user software in the SmartHome system.
Meaning of the symbols in the display
Displays the quality of the radio recep-
tion. A continuous light signals good radio
reception. The symbol flashes if the radio
transmission is weak.
Shows that frost protection has been acti-
vated.
Shows that the batteries are worn out.
Please change the batteries immediately.
Displays an open window. This appears if
a window contact is open or if there is a
dramatic fall in temperature (e.g. open
window).
Shows which operating mode has been
activated. (manual / automatic)
The control pin is fully retracted to make
A1
installation easier.
The control pin has fully retracted and the
A2
radiator thermostat can be installed.
The control range is identified and self-ad-
A3
justment for the complete range of func-
tions takes place.
General information
eQ-3 Entwicklung GmbH hereby declares that this
device meets the basic requirements and the other
relevant regulations laid down in Directive 1999/5/
EC.
You can find the complete declaration of conformity
at:
www.eq-3.de/rwe-smarthome
eQ-3 Entwicklung GmbH,
Maiburger Str. 36,
D-26789 Leer
4
Publicité
