Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY
ALIGNING THE LASER GUIDE LINE
See Figure 22.
DANGER:
Laser radiation. Avoid direct eye contact with light
source.
WARNING:
Use of controls or adjustments or performance of
procedures other than those specified herein may
result in hazardous radiation exposure.
Draw a line on the tile. When the laser guide switch is turned
on it will generate a red line on the work surface. This line will
let you see your mark and the laser guide line at the same
time, and will assist you in lining up the mark for more ac-
curate cutting of the tile.
Align the laser line and the mark with the wheel in the
cutting position using the laser adjustment dial. Once both
lines are in alignment, do not move the tile.
Make several practice cuts on different styles and thickness
of material. Repeat the steps above as necessary.
Follow the directions below for using the laser guide:
Removing Your Mark:
Position the laser line near the left edge of your mark on the
work surface in order to remove the mark.
To Cut Your Mark:
Position the laser line near or over your mark on the work
surface in order to cut the mark.
To Leave Your Mark:
Position the laser line near the right edge of your mark on
the work surface in order to leave the mark.
After you have become familiar with using the laser guide,
you will be able to remove, cut, or leave your mark on the
work surface. Practice will teach you the correct position for
aligning the laser line with your mark.
To reduce the risk of injury, the user must read and understand operator's manual.
•
•
Wear eye, hearing, and respiratory protection when operating the tool.
Do not remove the wheel guard.
•
Never operate the tool without the wheel guard securely closed.
•
Turn off tool, wait for the wheel to stop moving and disconnect the power
•
to the tool before servicing, when changing cutting wheels, or cleaning.
Never use wheels that have openings, grooves, or teeth on this tool.
•
•
Always inspect and replace damaged cutting wheels before operating the tool.
Do not expose to rain or other damp locations.
•
•
Do not fill water bath above maximum water fill line.
•
Do not stack or store tiles on water trays.
20 — English
red
line
WARNING
DANGER
LASER RADIATION AVOID DIRECT EYE EXPOSURE
MAXIMUM OUTPUT: <5mW WAVELENGTH: 630-660nm
CLASS IIIa LASER PRODUCT
laser Guide
switch
laser
adJustMent
dial
Fig. 22
Publicité
