Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY
To open the leg stand:
Step on the release lever and pull the grips toward you
at the same time.
Once the leg stand is released from the release lever,
ease the leg stand toward the floor by pushing the grips
toward the floor.
With your hands on the grips, push the leg stand towards
the ground until the saw is in an open position.
NOTE: The release lever will close over the center brace
locking the leg stand in an open position.
TILE CUTTING WHEEL
For maximum performance and safety, it is recommended
that you use the 10 in. cutting wheel provided with your
saw. Additional cutting wheels of the same high quality are
available at your local dealer.
WARNING:
Do not use cutting wheels rated less than the no
load speed of this tool. Failure to heed this warning
could result in personal injury. Do not use wheel
with cracks, gaps, or teeth.
WARNING:
To prevent possible electrical hazards, have a
qualified electrician check the line if you are not
certain that it is properly wired.
18 — English
Fig. 19
Publicité
