RIDGID R4010 Manuel D'utilisation page 16

ASSEMBLY
INSTALLING THE MITER GUIDE
See Figure 13.
The miter guide can be used from both the left and right side
of the cutting wheel.
 Place the slot on the underside of the miter guide on the
sliding table fence.
 Lock the miter guide securely to the table by turning the
miter guide knob clockwise.
To adjust angles:
 Loosen the lock knob.
 Set to the desired angle by moving the guide left or
right.
 Tighten the knob securely before turning on the saw.
INSTALLING SLIDING TABLE ExTENSION
See Figure 14.
 From the side of the saw, align the pins on the sliding table
extension with the holes in the sliding table frame.
 Secure in place by turning the table extension lock knob
underneath the extension clockwise.
INSTALLING THE READY RACK™ TILE
CARRIER
See Figure 15.
Snap the carrier over the upper tube on the leg stand. The
carrier provides a storage area for cut tiles while the holes
in the bottom allow water to drain away from the tiles.
Miter
locK
Guide
KnoB
Miter
Guide
KnoB
slidinG
Fig. 13
slidinG
taBle
extension
readY racK™
tile
carrier
taBle
fence
16 — English
slidinG
taBle
taBle extension
riGht
uPPer
tuBe
locK KnoB
Fig. 14
Fig. 15