Important Information; Introduction; Included Parts - Munchkin 46760 Notice D'utilisation

Important Information

INTRODUCTION

Thank you for choosing a Munchkin safety gate to help protect your family. Your gate stays
in place by creating pressure between two opposing surfaces.
For maximum security, DO NOT use this gate in any location without installing all 4 wall
cups, sticky pads, and screws provided. In some openings only 2 top wall cups can
be fitted.
Please inspect your gate immediately. If you see any damage, do not attempt installation.
Check page 16 of this manual for information on damaged products.
Assemble the gate away from small children. Some of the parts may present a choking
hazard when loose.
PLEASE NOTE: There is a gap between your gate frame and
handle. This is not a defect. This gap will close once your gate
is properly installed. Please check the gate on a regular basis to
ensure that all parts are in proper working condition.
DISCLAIMERS
Any misuse, abuse, abnormal use, excessive wear and tear, improper assembly,
negligence, environmental exposure, accident or alteration of the gate, as well as removal
or alteration of its serial number, invalidates any and all claims against the manufacturer.
Any damage to property during installation is the sole responsibility of the end user.
WARNING:
• Children have died or been seriously injured when gates are not
securely installed.
• ALWAYS install and use gates as directed using all required parts.
• Install according to manufacturer's instructions.
• This product will not necessarily prevent all accidents. Never leave
child unattended.
• NEVER use to keep child away from pool.
• Use only with the locking mechanism securely engaged.
• STOP using when a child can climb over or dislodge the gate.
• Intended for use with children from 6 months through 24 months.
4

INCLUDED PARTS

If any parts are missing or damaged, please contact our Customer Satisfaction Team
at 1-800-344-2229.
Adjustment rod with threaded
nut (x4) (Pre-installed)
Wall anchor (x4) Wall screw (x4)
TOOLS NEEDED:
• Drill • Pencil
• Phillips screwdriver • Tape measure
• Flathead screwdriver
Getting Started
Gate (x1)
2.75" (7cm) small
extension (x2)
(Pre-installed)
Wrench Wall cup & round
sticky pad (x4)
5