Cleaning - Philips HR2345/17 Mode D'emploi

ENGLISH
14
Note: The appliance will not start working if the chamber lid is not properly closed.
During the pasta making process, if the chamber lid becomes loose, the appliance
will automatically stop working.
3 Turn the control knob to select the auto operation setting, and then press the Start/
Pause button. (Fig. 31)
Note: The whole working process (including kneading and extruding) takes around 12
minutes for 200g of flour and 18 minutes for 400g of flour.
4 After the kneading starts, slowly pour in the liquid along the entire length of the slot
in the lid. (Fig. 32)
Note: During dough mixing, do not add other ingredients after you have poured in
the liquid. Otherwise, it will affect the results of the pasta texture.
5 After the Pasta maker finishes kneading, it will beep a few times and the pasta
extrusion will start after a few seconds. Place a container right under the outlet. Cut
the pasta into the desired length with the cleaning tool. (Fig. 33)
Note
y If the ratio of liquid and flour is not correct, the extrusion will not succeed. In this
case, prepare the ingredients again.
y Move the cleaning tool downwards to cut the pasta.
6 When the extrusion process is complete, the appliance will beep a few times.
Note: Do not turn the control knob to the "OFF" position before the whole process is
over (you will hear the "beep" sound).
7 After the pasta making is complete, if you notice some leftover dough inside the
chamber, you can turn the control knob to the OFF position first, and then turn the
control knob to the extra-extrusion setting. Press the Start/Pause button to start the
extra-extrusion program. (Fig. 34)
Note
y You may find some fine pasta threads on the pasta surface. This is normal.
y The cooking time of the pasta varies depending on personal preferences, pasta
shapes, and number of servings.

Cleaning

Important
y Turn the control knob to "OFF", disconnect the power and remove the power cord
before cleaning or disassembling this appliance.
y Do not immerse the main unit in water.
y Do not use a scouring pad, caustic cleaners, or abrasive cleaners (for examples,
gasoline, alcohol, and propanol) to clean the appliance.
y Clean the appliance each time after use, or the appliance might not operate
properly.
y Take extra caution when cleaning the appliance to avoid getting cut by any sharp
edges.
y The shaping discs and all detachable parts of the appliance are dishwasher safe.
When you clean them in a dishwasher, make sure to select the proper program
which has a maximum temperature at no higher than 60°C.