Samsung Pure Cycle WF231 Serie Informations Techniques page 12

ALIGNMENT AND ADJUSTMENTS
To avoid risk of electrical shock, personal injury or death; disconnect power to washer
before servicing, unless testing requires power.
Demo Mode
- Demo mode is entered when the Delay Start + Soil Level buttons are held down for five (5)
seconds simultaneously in the power on state.
- When entering Demo mode, the buzzer rings three (3) times and "- - - -" is displayed on the 7
segment display and all other LEDs are turned off. (Initial Demo mode)
- Demo mode consists of WASH, SPIN and LED modes.
- If the Temp button is pressed during the initial Demo mode, "WASH" blinks on the 7 segment
display and the washing machine enters WASH mode.
- If the Start/Pause button is pressed in WASH mode, the door is locked (Door Lock) and the motor
rotates left and right at 45 RPM in a 7 sec on and 3-sec off cycle.
- WASH mode continues up to five (5) minutes once started. After the five (5) minutes have
elapsed, "- - - -" is displayed on the 7 segment display and the initial Demo mode is maintained.
- If the Start/Pause button is pressed during a WASH mode operation, "- - - -" is displayed on the 7
segment display and the initial Demo mode is maintained.
- If the Spin button is pressed in the initial Demo mode, "Spin" blinks on the 7 segment display
and the washing machine enters SPIN mode.
- If the Start/Pause button is pressed in the SPIN mode, the door is locked (Door Lock) and a spin
is operated at 1150 RPM. When the speed reaches 0 RPM, the No Spin, Low, Medium, High, and
Extra High LEDs are turned on.
- During a spin operation, the No Spin LED turns on when the speed is lower than 400 RPM. The
Low LED turns on between 400 RPM and 700 RPM. The Medium LED turns on between 700 RPM
and 900 RPM. The High LED turns on between 900 RPM and 1100 RPM. All spin speed LED turn
off more than 1100 RPM.
- SPIN mode continues up to four (4) minutes once started. After the four (4) minutes have
elapsed, "- - - -" is displayed on the 7 segment display and the initial Demo mode is maintained.
- If the Start/Pause button is pressed during a SPIN mode operation, "- - - -" is displayed on the 7
segment display and the initial Demo mode is maintained.
- If the Start/Pause button is pressed in LED mode, all LEDs are turned on. The LED mode
continues up to thirty (30) seconds once started. After the thirty (30) seconds have elapsed, "- - -
-" is displayed on the 7 segment display and the initial Demo mode is entered.
- If the Start/Pause button is pressed during an LED mode operation, "- - - -" is displayed on the 7
segment display and the initial Demo mode is entered.
[BingBang2] Technical_information_02830C-01_EN.indd 12
WARNING
12
2012-10-05 3:26:50