en
Service programmes
■ Rinse all parts with clean water and dry
them.
F
The upper and lower parts of the milk
system 4b, the milk tube 4c and the
suction pipe 4d can also be cleaned
in a dishwasher.
■ Reassemble the individual parts.
■ Place the milk system 4b back in the
appliance from the front, making sure it is
straight.
■ Replace the cover 4a.
Cleaning the brewing unit
(Figure G)
F
See also the Quick reference guide in
the storage compartment 16.
In addition to the automatic cleaning
programme, the brewing unit 14 should be
removed regularly for cleaning.
■ Use the main switch J 1 to switch the
appliance completely off.
■ Open the door 13 to the brewing unit.
■ Slide the red latch 14a on the brewing
unit 14 all the way to the left.
■ Press the eject lever 15 right down. The
brewing unit will be released.
■ Take hold of the brewing unit 14 by the
recessed grips and carefully remove it.
F
Important: Clean it without using
washing-up liquid and do not put it in
the dishwasher.
22
■ Remove the cover 14b and thoroughly
clean the brewing unit 14 under running
water.
■ Thoroughly clean the strainer of the
brewing unit under the water jet.
■ Thoroughly clean the inside of the appli-
ance with a moist cloth, removing any
coffee residues.
■ Allow the brewing unit 14 and the inside
of the appliance to dry.
■ Replace the cover 14b on the brewing
unit and then push the brewing unit 14
back into the appliance until it latches into
place.
■ Press the eject lever 15 right up.
■ Slide the red latch 14a all the way to the
right and close the door 13.
Service programmes
F
See also the Quick reference guide in
the storage compartment 16.
Following prior notification, either
Descaling necessary or
Cleaning necessary or
calc'nClean necessary.
appears in display 3 at certain intervals.