Publicité
Les langues disponibles
Les langues disponibles
NOTE
Water condensation on the bottom side of the appliance could happen if there is
poor ventilation in a wet environment. It's not a fault of the product and it could be
fixed by turning the adjustable feet of the product to the higher maximum position in
order to increase the space between the bottom surface and the floor.
WHAT IS WHEN............
a)
No function (appliance not running)
Attention!
In the event of problems or of a power failure, the insulation of the appliance walls
provides 10 to 12 hours storage time after the beginning of such failures.
Considerably more time is available in specially insulated appliances. Ask your
dealer what is the suitable "storage time after problems" for your appliance.
If it takes longer to eliminate a problem, the frozen food in the appliance begins to
defrost. Therefore, take prompt action to eliminate the problem and, if necessary,
shift frozen food into another appliance (possibly neighbor).
b)
Appliance not cooling sufficiently Freezing process too long Compressor
operating too often
Possible causes/Remedies:
• Did you have the appliance t stand for at least 2 hours before switching it on?
(Stabilize the refrigerant flow circuit). See: "Start-up".
If not: unplug when the chest is closed, lift the chest for a brief moment and then put
it back down to its original position. After 2 hours put the plug back in. Do not open
the chest during this period and a further 12 hours afterwards, i.e. until the red light
goes off.
• Is the plug in good condition and is it properly plugged into the socket?
• Is the socket under current? (if necessary, test by connecting a small appliance
such as a hand-mixer, etc.).
-34-
Publicité
