emerio SEW-121821 Mode D'emploi page 8

2. Replacing the bottom bobbin
1) Slide the bobbin cover button to the right and remove the bobbin cover (Fig.7).
2) Put the new bobbin in the holder, with the thread going clockwise. Leave 10cm of thread hanging out
(Fig.8).
3) Make a loop and put it in the hole under the needle.
4) Hold the end of the upper thread with one hand, and turn the hand wheel counterclockwise with the
other hand, the needle thread will pick up the bobbin thread and pull it up through the hole under the
needle (Fig.9).
5) Replace the bobbin cover and separate the two threads and pull them to the back of the machine under
the presser foot, leaving about 15cm hanging there. (Fig. 10)
Caution:

Always switch off the appliance, disconnect it from the power supply and remove the foot pedal when
replacing the bottom bobbin.

Please use metal bobbins, otherwise the magnetic holder cannot tense the bobbin thread and work
rightly.
SEWING
1. Turn the hand wheel counterclockwise to raise the needle to its highest position.
2. Raise the presser foot lifter and place the fabric you want to sew under the presser foot (Fig.11).
3. Lower the presser foot. (Fig.12).
4. Rotate the pattern selection dial to select the stitch pattern you wanted.
Caution:

Before you change the stitch pattern, please turn off the switch and turn the hand wheel to raise the
needle all the way up so it doesn't get stuck and bent.

Changing the stitch pattern is not allowed when the machine is running, otherwise the needle and/or
machine may damage.
5. Turn the hand wheel several times to make sure there is no jamming in the stitches.
6. Slide the power switch to the position "L" (meaning low speed) or "H" (meaning high speed), and the
machine will automatically start sewing. We recommend the low speed for beginners (Fig.13).
7. When you finish the sewing, turn off the switch, unplug the adapter, turn the hand wheel to raise the
needle all the way up, lift the presser foot, and then gently remove the fabric from the sewing machine,
and cut the thread with the thread cutter (Fig.14).
Tips:

Please turn the hand wheel if it is difficult to remove the fabric, and then pull out the fabric gently.
Fig.7
Fig.9
- 7 -
Fig.8
Fig.10