Télécharger Imprimer la page

Franke FTC 542 Mode D'emploi Et Installation page 7

Publicité

Les langues disponibles

Les langues disponibles

INSTALLATION
• The Hood can be installed directly on the un-
derside of wall-mounted units (650 mm min.
from the Cooker Top) using the snap-on side
supports.
• According to requirements, fit two of the sup-
port brackets for the hood (see table fig. 1) at a
distance of 125 mm from the front of the wall-
mounted unit.
• According to the chosen air outlet diameter,
insert the appropriate flange into the upper ex-
haust outlet. (fig.2)
• Measure the depth of the wall-mounted unit.
(fig.3)
• Measure the depth of the hood plus the depth of
the fastening profile 20 or 21 or 22 (fig. 3) up
to the end of the wall-mounted unit (fig. 3)
• If necessary, assemble the profile 21 with 20 or
with 22 with 2 screws 12g (2,9 x 6,5) provided
in order to cover the gap between the hood and
the wall.
• Screw the fastening profile to the rear part of
the hood using screws 12f (2.9 x 9.5) provided.
(fig.4)
• Open the ducting carriage.
• Remove the metal grease filters one at a time,
releasing the fasteners provided.
• Close the ducting carriage.
• Insert the Hood until it connects with the snap-
on side Supports. (fig.5)
• Open the ducting carriage.
• Lock it in position by tightening screws Vf from
underneath the Hood. (fig.5)
• Should it be necessary to make adjustments to
the inside of the filter holder element, proceed
as follows:
• Loosen the four adjustment screws Vr and
close the carriage again. (fig.6)
• Move the whole filter holder element until it
is properly aligned with the wall-mounted
unit. (fig.7)
• Holding the hood canopy still, extract the
carriage and tighten the adjustment screws
Vr. (fig.6)
• It is now possible to fasten the hood to the
wall-mounted unit using the screws 12a (3.5
x 16) provided. (fig.8)
• Replace the metal grease filters.
• Close the ducting carriage.
EN
Drilling the Support surface and Fitting the Hood
1
X
10b
10a
9
2
10
20
4
5
7
Nische / Niche /
Haltewinkel /
Nicchia
Cornières /
Staffe
X
SMS
550 mm
25 mm
518-512 mm
9 mm
3
22
21
12g
V
6
12a
8
7
7

Publicité

loading

Ce manuel est également adapté pour:

Ftc 642