DETAIL K2 MFT4X8G Manuel Du Propriétaire page 8

1. Flip the connected front and rear bed assemblies over, so they are upside down.
2. Position drawbar (5L, 5R) to the trailer front bed (26), fitting the bars into the U slots on the front
cross member.
3. Use L latch (37) to go through the U bracket and lock with R clip after then.
4. Use M10 x 30 (36), M12 x 25 (39) to connect the drawbar end to trailer side rails. Do not tighten the
bolts until all bolts in position.
5. Connecting drawbar T plate (3), drawbar coupler base (4) as shown with M10 x 20 (34)
Item N Description
o.
3 Tow bar T-plate
4 Coupler base
5 Tow bar
34 Hex M10 x 20 bolt & nut (set)
�ig.2
8 8
MFT4X8G man MFT4X8G man
ASSEMBLY ASSEMBLY
STEP 2 STEP 2
DRAWBAR ASSEMBLY
Qty. Item N
36
1
37
1
2
39
12
Description
o.
Hex bolt M10 x 30 & nut (set)
Hitch pin Ø12 x 75 & R clip
(set)
Hex bolt M12 x 25 & nut (set)
Qty.
2
2
2