DETAIL K2 MFT4X8G Manuel Du Propriétaire page 12

1. Locate both tire/hub assemblies. For easy access, be certain that grease fittings are facing out
away from the hub as shown in figure 6-1.
2. Remove hubcap (21) using a small pry bar between the flange on the hub cap and the face of the
hub (fig.6-2a).
3. Remove 4 mm cotter pin (L), bearing (20) and washer (N). See figure 6-2b.
4. Remove castle nuts (H) from axle ends.
12 12
MFT4X8G man MFT4X8G man
ASSEMBLY ASSEMBLY
STEP 6 STEP 6
TIRE ASSEMBLY
�ig.6-1
21
�ig.6-2a
�ig.6-2b