WIKA intelliTHERM TGT73.100 Mode D'emploi page 20

5. Commissioning, operation
Dismounting cable socket
The cable socket is prefitted and must be dismantled as described
below.
EN


Screw

Cable cover cap

Cable cover

Socket insert

Cable socket baseplate

Sealings

Fully loosen the screws on the cable cover cap with a slotted
■
screwdriver (0.6 x 3.5 mm) and remove them.
Pull the cable cover, along with the socket insert, out from the cable
■
socket baseplate (joined permanently with the instrument).
Take the cable cover cap and push the socket insert out, downwards,
■
completely through the cable cap.
20


WIKA operating instructions model TGT73 (Ex)
Only use cable with a
diameter of 7 ... 13 mm


