Télécharger Imprimer la page

Beko KSSA2933WN Notice D'utilisation page 11

Publicité

Les langues disponibles

Les langues disponibles

EN
Temperature control and adjustment
The internal temperature could be adjusted by
means of the button from the thermostat.
The temperatures obtained inside the
appliance could oscillate depending on the
usage conditions: location, environmental
temperature, doors opening frequency, foods
quantity. Position of thermostat button will
change depending on these conditions.
Generally, for an environmental temperature
of 25°C (77°F), thermostat button will be
settled on a medium position.
Avoid some positions of thermostat button
that could involve a continuously running of
the appliance. This could involve a
temperature decrease under 0°C, therefore
the drinks and fresh foods could freeze and
an excessive ice quantity could be
accumulated on the internal wall. All these
above mentioned could involve a decrease of
the refrigerating efficiency (increase of the
power consumption).
Before operating
Final Check
Before you start using the appliance check
that:
1. The feet have been adjusted for perfect
levelling.
2. The interior is dry and air can circulate
freely at the rear.
3. The interior is clean as recommended
under "Cleaning and care."
4. The plug has been inserted into the wall
socket and the electricity is switched on.
When the door is open the interior light will
come on.
And note that:
5. You will hear a noise as the compressor
starts up. The liquid and gases sealed within
the refrigeration system may also make some
(noise), whether the compressor is running or
not. This is quite normal.
6. Slight undulation of the top of the cabinet
is quite normal due to the manufacturing
process used; it is not a defect.
7. We recommend setting the thermostat
knob midway and monitor the temperature to
ensure the appliance maintains desired
storage temperatures (See section
Temperature Control and Adjustment).
8. Do not load the appliance immediately it is
switched on. Wait until the correct storage
temperature has been reached. We
recommend checking the temperature with an
accurate thermometer (see; Temperature
Control and Adjustment).
4
Instruction for use

Publicité

loading