Mitsubishi Electric Mr.SLIM PEAD-A09AA8 Manuel D'utilisation page 7

3. Operation
3.4. Fan speed setting
Fri
83
Room
F
Cool Set temp.
83
F
Mode Temp. Fan
F1 F2 F3 F4
Press the [F4] button to go through the fan speeds in the following order.
• The available fan speeds depend on the models of connected indoor units.
Notes:
● T he number of available fan speeds depends on the type of unit con-
nected.
● In the following cases, the actual fan speed generated by the unit will
differ from the speed shown on the remote controller display.
1. While the display is in "STAND BY" or "DEFROST" states.
2. When the temperature of the heat exchanger is low in the heating
mode.
(e.g. immediately after heating operation starts)
3. In HEAT mode, when room temperature is higher than the tempera-
ture setting.
4. When the unit is in DRY mode.
3.5. Navigating through the Main menu
<Accessing the Main menu>
Main Main menu
Vane·Louver·Vent. (Lossnay)
High power
Timer
Weekly timer
OU silent mode
Main display:
Cursor Page
F1 F2 F3 F4
<Item selection>
Main Main menu
Vane·Louver·Vent. (Lossnay)
High power
Cursor
Timer
Weekly timer
OU silent mode
Main display:
Cursor Page
F1 F2 F3 F4
Auto
Press the [MENU] button.
The Main menu will appear.
Press [F1] to move the cursor down.
Press [F2] to move the cursor up.
<Navigating through the pages>
page
Main Main menu
Vane·Louver·Vent. (Lossnay)
High power
Timer
Weekly timer
OU silent mode
Main display:
Cursor Page
F1 F2 F3 F4
<Saving the settings>
OU silent mode
Mon Tue Wed Thu Fri Sat Sun
Start Stop Silent
-
Setting display:
day
F1 F2 F3 F4
<Exiting the Main menu screen>
Fri
83
Room
F
Cool Set temp.
83
F
Mode Temp. Fan
F1 F2 F3 F4
If no buttons are touched for 10 minutes, the screen will automatically
return to the Main display. Any settings that have not been saved will be lost.
<Display of unsupported functions>
Title
Not available
Unsupported function
Return:
F1 F2 F3 F4
3.6. Ventilation
►For LOSSNAY combination
● The following 2 patterns of operation are available.
• Run the ventilator together with the indoor unit.
• Run the ventilator independently.
Note:
● W ith some model configurations, the fan on the indoor unit may come on even
when you set the ventilator to run independently.
Note (for IR wireless remote controller and RF thermostat):
● R unning the ventilator independently is not available.
● N o indication on the remote controller.
Press [F3] to go to the previous page.
Press [F4] to go to the next page.
Select the desired item, and press the
[SELECT] button.
The screen to set the selected item will
appear.
Press the [RETURN] button to exit
the Main menu and return to the Main
display.
The message at left will appear if the
user selects a function not supported
by the corresponding indoor unit model.
7