Mitsubishi Electric Mr.SLIM PEAD-A09AA8 Manuel D'utilisation page 6

3. Operation
■ About the operation method, refer to the operation manual that comes with each remote controller.
3.1. Turning ON/OFF
[ON]
Press the [ON/OFF] button.
The ON/OFF lamp will light up in green,
and the operation will start.
Note:
Even if you press the ON/OFF button immediately after shutting down the operation is progress, the air conditioner will not start for about 3 minutes.
This is to prevent the internal components from being damaged.
■ Operation status memory
Operation mode
Preset temperature
Fan speed
■ Settable preset temperature range
Operation mode
Cool/Dry
Heat
Auto
Fan/Ventilation
3.2. Mode Selection
Press the [F1] button to go through the opera-
Fri
tion modes in the order of "Cool", "Dry", "Fan",
"Auto", and "Heat". Select the desired operation
83
Room
F
mode.
Cool Set temp. Auto
83
F
Mode Temp. Fan
F1 F2 F3 F4
• Operation modes that are not available to the
connected outdoor unit models will not appear
on the display.
What the blinking mode icon means
The mode icon will blink when other indoor units in the same refrigerant
system (connected to the same outdoor unit) are already operated in a
different mode. In this case, the rest of the unit in the same group can
only be operated in the same mode.
Automatic operation
■
According to a set temperature, cooling operation starts if the room tempera-
ture is too hot and heating operation starts if the room temperature is too cold.
■
During automatic operation, if the room temperature changes and remains
2.0 °C, 4 °F or more above the set temperature for 15 minutes, the air con-
ditioner switches to cool mode. In the same way, if the room temperature
remains 2.0 °C, 4 °F or more below the set temperature for 15 minutes, the
air conditioner switches to heat mode.
Cool mode
15 minutes (switches from
heating to cooling)
15 minutes (switches from
cooling to heating)
6
Remote controller setting
Operation mode before the power was turned off
Preset temperature before the power was turned off
Fan speed before the power was turned off
Preset temperature range
67 - 87 ºF/19 - 30 ºC
63 - 83 ºF/17 - 28 ºC
67 - 83 ºF/19 - 28 ºC
Not settable
Cool Dry
Auto Heat
Set temperature +2.0 °C, +4 °F
Set temperature
Set temperature -2.0 °C, -4 °F
[OFF]
3.3. Temperature setting
<Cool, Dry, Heat, and Auto>
83
Room
F
Cool Set temp.
83
Fan
F
Mode Temp.
F1 F2 F3
Press the [F2] button to decrease the preset temperature, and press the [F3]
button to increase.
• Refer to the table on page 6 for the settable temperature range for dif-
ferent operation modes.
• Preset temperature range cannot be set for Fan/Ventilation operation.
• Preset temperature will be displayed either in Centigrade in 0.5- or 1-degree
increments, or in Fahrenheit, depending on the indoor unit model and the
display mode setting on the remote controller.
Press the [ON/OFF] button again.
The ON/OFF lamp will come off, and
the operation will stop.
Fri
84
Room F
Auto Cool Set temp.
84
F
Fan Mode Temp.
Example display
(Centigrade in 0.5-degree increments)
F4
Fri
Auto
Fan